Intelligent Duplication Modes
U-Reach MT-U Series SATA HDD duplicator is capable of copying at 30GB/min. on all targets simultaneously, without any speed degradation as number of targets increase. This duplicator is great for manufacturers.
Illustration of Copy Modes
The areas containing data are marked in blue. The areas being copied are marked in red. Duplication time depends on the speed supported by the hard drive’s controller chip.
Erase HDD index table, and only takes A FEW SECONDS to complete.
Erases the entire HDD.
Complies with U.S. Department of Defense erasure standards.
A National Institute of Standards and Technology 800-88 accepted
technique for properly purging hard drives. This method is supported by almost all modern SATA/SAS HDD.
Auto Rejection of Slow Devices
MT-U Series HDD/SSD duplicator enable end-users to set the minimum writing speed threshold. This feature was developed to prevent and to eliminate problematic devices that halts the duplication and sanitizing process.
Double Data Verification: Compare + CRC Checksum
U-Reach duplicators makes straightforward copies, but it is imperative that the copied data are verified through a bit-by-bit process, this will ensure successful copied and reduce customer recalls.
Skipping Bad Sectors
End-users are given options to skip bad sectors from the source device. Access the function to select the numbers of bad sectors to skip, from 0 through unlimited.
Optional Adapters Supported
Event Log Report
U-Reach HDD/SSD duplicators has an unique mechanism to prevent alteration of its Event Log Report. It records the operation results and other information of each devices completely. It is an important asset for production management and analysis.